|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-03-2013, 12:35 PM
|
#1 |
|
Registered User
Join Date: Mar 2001
Location: Tucson, Arizona
Posts: 26
|
3/4-t vs. 1-ton spindles
I picked up a front cross member from what I was told was an early 70's 1-ton with disc brakes. I'd like to use the spindles for a disc brake conversion I'm doing on a 3/4-ton '65. Were 1-ton and 3/4-ton spindles the same in that era? Is there an easy way to identify what I really have?
|
|
|
|
06-03-2013, 09:25 PM
|
#2 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: 3/4-t vs. 1-ton spindles
Bump.....anyone know?
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
06-03-2013, 10:57 PM
|
#3 |
|
Registered User
Join Date: Mar 2012
Location: Knoxville, TN
Posts: 5,381
|
Re: 3/4-t vs. 1-ton spindles
I believe if you have single rear wheel 1 ton spindles its the same but if you have dually spindles they're different.
__________________
-Rus |
|
|
|
|
06-03-2013, 11:42 PM
|
#4 |
|
Registered User
Join Date: Aug 2010
Location: Edwards, CA
Posts: 7,503
|
Re: 3/4-t vs. 1-ton spindles
Looks like the same service part numbers for C20-30 and G30 w/DB. No mention of DRW either way.
__________________
Thanks, Tim * VIN/Model Decoders * Power Team Charts (engine/transmission/gear ratio) * Post Your Pickup SPID ** Blazer SPID ** Suburban/Panel SPID * RTFM ... Read The Factory Manuals... download 'em here Highlanders ** Do you have a 1972 Plaid Pickup? ** Plaid Blazer ** Plaid Suburban |
|
|
|
|
06-03-2013, 11:45 PM
|
#5 |
|
Registered User
Join Date: Mar 2001
Location: Tucson, Arizona
Posts: 26
|
Re: 3/4-t vs. 1-ton spindles
Thanks for the par numbers. With a little luck they'll match the numbes on the spindles. I'll check tomorrow.
Last edited by vpersh; 06-03-2013 at 11:54 PM. |
|
|
|
|
06-04-2013, 10:47 AM
|
#6 |
|
Registered User
Join Date: Mar 2001
Location: Tucson, Arizona
Posts: 26
|
Re: 3/4-t vs. 1-ton spindles
The spindles on the front end I have carry the numbers 3989485LH and 3989486RH. Does your parts book show anything for them?
  Thanks, |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
