|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-04-2013, 02:19 PM
|
#1 |
|
Registered User
 
Join Date: Mar 2002
Location: Dallas, TX
Posts: 555
|
Gas Signal Wire Thru Firewall. Where?
I moved my gas tank from behind the seat to under the bed. I am running a new Blazer sending wire and would like to know where to penetrate the firewall. Is it the same for Suburban and Blazer?
Erl
__________________
1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX |
|
|
|
06-04-2013, 03:04 PM
|
#2 |
|
Registered User
Join Date: Feb 2009
Location: southeasternfoothillsofusa
Posts: 1,557
|
Re: Gas Signal Wire Thru Firewall. Where?
Why not run it thru a hole behind seat(thru floor) and then underneath carpet or sill mldg. to dash area?--small hole/small plug! No safety issues--it's merely a ground, right?
Sam. |
|
|
|
|
06-04-2013, 07:51 PM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Gas Signal Wire Thru Firewall. Where?
The Suburban wire to the sending unit goes up the A pillar and follows the roof edge to the rear, through the floor and to the tank. Not sure where the Blazer wire runs but it is not like the Burb.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
