|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-07-2013, 11:51 PM
|
#1 |
|
Registered User
Join Date: Dec 2001
Location: Manteca, Ca USA
Posts: 305
|
Rotor Bearing packing Help
So I pulled the front rotors off my 71 c20 to swap them and noticed that the area in between the front and back bearing races are packed full of grease too. Not sure why- this area doesn't touch the spindle right? I always thought it was just the bearing and race that needed grease- am I wrong?
__________________
'71 Chevy 3/4 Ton Longbed '22 Chevy Tahoe RST '67 Firebird- 8 sec street car '24 GMC CC 4x4 Duramax Dually |
|
|
|
08-08-2013, 12:47 AM
|
#2 |
|
Registered User
 
Join Date: Jul 2013
Location: Forestburg, Texas
Posts: 659
|
Re: Rotor Bearing packing Help
Grease is here as a reserve. It is a good idea to keep grease to make sure the bearings don't run dry from migration.
__________________
Mark Jesus is the Way! 2003 2500HD CCLB Duramax/Ali (Clifford) 2014 2SS/RS black on black Camaro (Betty) 2006 Pontiac SOLSTICE silver/black (Lula-Bell) 1970 C/10 Short Wide (Peggy) 1964 C/10 Short Step (Hambone) RIP Jimmy Hamilton Thank you for the trucks |
|
|
|
|
08-08-2013, 12:59 AM
|
#3 |
|
Registered User
Join Date: Jul 2012
Location: Maple Ridge. B.C.
Posts: 145
|
Re: Rotor Bearing packing Help
I agree with the previous post. I'm a H.D. Mechanic by trade. I always pack the rotor hub cavity and coat the spindle with grease. Also it helps prevent rust to form from condensation when it gets hot then sits.
Posted via Mobile Device |
|
|
|
|
08-08-2013, 11:08 AM
|
#4 |
|
Registered User
Join Date: Dec 2001
Location: Manteca, Ca USA
Posts: 305
|
Re: Rotor Bearing packing Help
thanks guys
__________________
'71 Chevy 3/4 Ton Longbed '22 Chevy Tahoe RST '67 Firebird- 8 sec street car '24 GMC CC 4x4 Duramax Dually |
|
|
|
|
08-08-2013, 12:09 PM
|
#5 |
|
Old Skool Club
Join Date: Jun 2001
Location: Benton, AR "The Heart of Arkansas"
Posts: 10,880
|
Re: Rotor Bearing packing Help
If you don't, the grease worms could get in and make for a lot of trouble!!
__________________
Member Nr. 2770 '96 GMC Sportside; 4.3/SLT - Daily driven....constantly needs washed. '69 C-10 SWB; 350/TH400 - in limbo The older I get, the better I was. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
