Center Cpnsole Mounting bolt size - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**nitrosport_5** · 08-08-2013, 01:13 AM

I am converting my truck over to factory buckets and am wondering what size bolt the center console uses to mount to the cab floor. Is it 5/16-18 like the seat tracks? and is there supposed to be a welded square nut on the underside of the cab?

Thanks!

**FirstOwner69** · 08-08-2013, 01:21 AM

They are hex head sheet metal screws with washers very similar, if not identical, to the screws that fasten the fan shroud to the top radiator brackets. No reinforcement of any kind under the floor. Just screwed to the floor pan.

08-08-2013, 01:13 AM	#1
nitrosport_5 Registered User Join Date: Jul 2012 Location: St. John, Washington Posts: 618	Center Cpnsole Mounting bolt size I am converting my truck over to factory buckets and am wondering what size bolt the center console uses to mount to the cab floor. Is it 5/16-18 like the seat tracks? and is there supposed to be a welded square nut on the underside of the cab? Thanks! __________________ "Rusty" 1972 K20 Cheyenne Super, 496, A/C, Tilt, Tach, Buckets, 4l80e/NP205, 4" Rancho Lift, 35" BFG AT "Ramp Truck" 1972 C30 Ramp Truck 350, Air Bags, Factory A/C. "1968" C10 Shortbed project

08-08-2013, 01:21 AM	#2
FirstOwner69 Senior Member Join Date: May 2010 Location: Wisconsin & Arizona Posts: 4,852	Re: Center Cpnsole Mounting bolt size They are hex head sheet metal screws with washers very similar, if not identical, to the screws that fasten the fan shroud to the top radiator brackets. No reinforcement of any kind under the floor. Just screwed to the floor pan. Last edited by FirstOwner69; 08-08-2013 at 01:47 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.