Stock bumper height front and rear of 64 chev shortbed

[truckeroy]

My 64 stepside shortbed had the front and rear springs cut by the PO. It looks good, but cutting the pigtail off the bottom of the rear springs was not smart. They took some steel bars to bolt accross the bottom coil of the spring. The front ones are just too low. I can't find the factory dimensions for the stock bumper heights in my books or on this site. Can anyone give me a close dimension front and rear so I know where to start? I want to have a modest lowered stance, but also want the tires I put under it to fill in the wheelwells. Thanks, Roy

[63c102013]

I dont know what the stock height is but I do know 5 front 7 rear and 4 front 6 rear look good. I would recommend looking around at trucks to see what you like and see if you can find the drop specs for that. Good luck

[truckeroy]

I can't believe that nobody knows the stock bumper height front and rear for my 64. I'm not looking for a precise measurment to the bumper bolts, just close would be OK. I'm just wanting a reference starting point. Thanks.

[Rich 5150 69]

Here you go...

[truckeroy]

Thanks! That gives me a place to start from.