|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-26-2004, 06:44 PM
|
#1 |
|
72 LONGHORN OWNER
Join Date: Sep 2002
Location: Seattle Wash.
Posts: 963
|
Glove Box Door Question
Getting ready to put on a wood grain glove box applique on the Longhorn glove box door...There are a few areas that I will need to sand down and remove some old "glue".."contact cement. And here it is after the sticker is added:
__________________
72-SUPER CHEYENNE/20 LONGHORN 70-C/30 DUALLY Last edited by Castiron9; 02-08-2004 at 09:47 PM. |
|
|
|
01-26-2004, 07:26 PM
|
#2 |
|
member #16
 
Join Date: Dec 1999
Location: Yuba City Ca.
Posts: 3,618
|
I would do the whole door. It will only look as good as the prep put into it. John
__________________
john http://67-72chevytrucks.com/vboard/showgroups.php board vendors  http://www.flickr.com/photos/1745471...7602865984234/ |
|
|
|
|
01-26-2004, 07:45 PM
|
#3 |
|
Account Suspended
Join Date: Jan 2003
Location: Shadow of Lambeau Field
Posts: 5,597
|
I'd sand the whole door inside and out, repaint, then put your wood grain on.
What are the three extra holes in the upper left for? |
|
|
|
|
01-26-2004, 09:35 PM
|
#4 |
|
72 LONGHORN OWNER
Join Date: Sep 2002
Location: Seattle Wash.
Posts: 963
|
I've asked myself that question too.....I am assuming that the 3 lower ones are for my Cheyenne Super emblem........The top 3 left corner???????They just seem to be to perfect for someone to have drilled them????Any ideas............
__________________
72-SUPER CHEYENNE/20 LONGHORN 70-C/30 DUALLY |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
