The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 04-21-2015, 09:28 AM   #1
67chevemall
Registered User
 
67chevemall's Avatar
 
Join Date: Apr 2003
Location: NB
Posts: 3,367
Question Clutch slipping?

Not sure if this makes sense but, when I put the gas peddle to the floor I get no hp to the rear wheels. The tranny or clutch just rev up. There is just enough power to get the truck to go forward but if you stomp on it something just spins and no horse power.

Clutch plates rusted together from sitting all winter?
Clutch is fried?

I check the fluid in the trany and it is good and brand new.

Not sure where to start. Any help would be awesome...
__________________
1968 Chevy C10 307 3ott fleetside
1967 Chevy C/10 V8, 3spd, fleetside lwb.Sold
1967 Chev C/10 step, 383, M21. SOLD

Last edited by 67chevemall; 04-21-2015 at 09:58 AM.
67chevemall is offline   Reply With Quote
Old 04-21-2015, 10:48 AM   #2
67chevemall
Registered User
 
67chevemall's Avatar
 
Join Date: Apr 2003
Location: NB
Posts: 3,367
Re: Clutch slipping?

After looking closer I think oil might be the cause. Lots of oil on the trans. Looks like main seal.


"If you've got oil in your clutch, you've got to figure out where it's coming from and fix it. It could be a trans seal, rear main seal, oil pan gasket, or if you're lucky, it's a bad pcv hose that's just dripping down the bellhousing and not on your clutch at all."
67chevemall is offline   Reply With Quote
Old 04-21-2015, 12:04 PM   #3
GRX
Registered User
 
GRX's Avatar
 
Join Date: Jul 2010
Location: MD
Posts: 1,937
Re: Clutch slipping?

Yeah, friction is essential. If things have been contaminated with oil that bad the clutch and pressure plate will need to be replaced. Flywheel resurfaced too most likely.
GRX is offline   Reply With Quote
Old 04-21-2015, 12:08 PM   #4
67chevemall
Registered User
 
67chevemall's Avatar
 
Join Date: Apr 2003
Location: NB
Posts: 3,367
Re: Clutch slipping?

Drain the geal oil out of the trans.
Drop the driveshaft.
Disconnect the shifter linkage.
Remove the 4 bolts holding the trans to the bellhousing.
Pull the trans stright away from the bellhousing.
Undo the trans/rear engine mounts, and unbolt the bellhousing from the engine.
Remove the bolts from the pressure plate, and bring down the clutch.
Remove the flywheel and get it machined.
When reassembling the clutch be sure to use the alinment tool.
Installation is reverse of removal.


Oboy it never does end does it....
__________________
1968 Chevy C10 307 3ott fleetside
1967 Chevy C/10 V8, 3spd, fleetside lwb.Sold
1967 Chev C/10 step, 383, M21. SOLD
67chevemall is offline   Reply With Quote
Old 04-21-2015, 12:10 PM   #5
hugger6933
Registered User
 
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,280
Re: Clutch slipping?

Getting oil on your clutch disc is just like when a wheel cylinder goes bad and leaks in the brake drum. You have to replace the friction material because the oily stuff will keep it from doing its thing, GRAB.
Plan on a clutch job. checking the oil level while a good idea is not gonna keep the trans from putting power to the rear wheels unless it is super low then of course it could be a problem ,major at that.
hugger6933 is offline   Reply With Quote
Old 04-21-2015, 12:39 PM   #6
67chevemall
Registered User
 
67chevemall's Avatar
 
Join Date: Apr 2003
Location: NB
Posts: 3,367
Re: Clutch slipping?

Well they have been together (383 and M21)for over 20 years so I guess it is time. That is 20 cold winters sitting on blocks too.
Main was dripping last fall I guess the winter finished it off.
67chevemall is offline   Reply With Quote
Old 04-21-2015, 03:40 PM   #7
67chevemall
Registered User
 
67chevemall's Avatar
 
Join Date: Apr 2003
Location: NB
Posts: 3,367
Re: Clutch slipping?

Anybody know what happens when it finally "goes"? Can I putt putt home or will I lose all drive?
67chevemall is offline   Reply With Quote
Old 04-22-2015, 02:58 AM   #8
treveiger
Senior Member
 
treveiger's Avatar
 
Join Date: Jul 2010
Location: South Dakota
Posts: 4,093
Re: Clutch slipping?

If the clutch goes? Depends how bad you burn it. Most I've seen can limp home(like 40mph floored). But will heat things up fast and the smell is awful.
__________________
1969 Chevy c20(Miss Hackjob)
treveiger is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:08 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com