|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-07-2015, 04:28 PM
|
#1 |
|
Registered User
Join Date: Jul 2015
Location: Benton, AR
Posts: 1
|
4x4 not working after trans rebuild 97 K1500
I need some help here guys. I had the transmission rebuilt and transfer case taken apart for inspection (was told it was good) by a local guy and both reinstalled by a "friend of a friend". Before they were pulled the floor shift lights lit up when I shifted to 4lo and 4high. Now that they're reinstalled the lights aren't working. Transfer case is engaging just don't think it's sending power to the actuator. I pulled the actuator and bench tested it and it seemed to work fine and also check the fuse. Any idea of what I need to check? Any help advice is greatly appreciated!
|
|
|
|
07-07-2015, 05:15 PM
|
#2 |
|
Registered User
Join Date: May 2015
Location: Montana
Posts: 3,696
|
Re: 4x4 not working after trans rebuild 97 K1500
There's a switch on the TC lever for the actuator and indicator lights.
I've never mucked with mine because I just rigged the front axle disconnect to be always engaged.
__________________
Current/past Chevy/GMC trucks: 1958 Chevy C-60; 1965 GMC C-50; 1965 Chevy C-10; 1971 Chevy K-10; 1973 Chevy K-20; 1976 GMC C-20; 1977 Chevy C-10 Suburban; 1980 Chevy K-10; 1989 Chevy K1500; 1991 GMC V1500 Suburban; 2016 Chevy K2500 HD Other vehicles: 1988 Jeep XJ; 2011 Toyota 4Runner |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
