VA 71 high hump cab and 71 blazer patches f/s

[billsbowtie]

couple patches already cut patch that goes around where the high hump was removed with threaded bolt wholes $20.00 plus $15.00 shipping.
other patch is where gas pedel bolts to floor/firewall if someone is useing a 71/72 gas pedel on a 67/70 this patch has the threaded bolt wholes for the 71/72 gas pedel $25.00 shipped.
if you need a patch post a pic. and i will see if it is good on my cab and give you a price on it. 6" by 6" patches $10.00 plus $10.00 shipping 12" by 12" patches $15.00 plus $10.00 shipping .

[billsbowtie]

[billsbowtie]

this cab has been patched on before so the outer floor have been patched before and the cab corners have had work done to them so may not be any good.

[billsbowtie]

[billsbowtie]

non a/c dash complete $100.00 plus $25.00 shipping.

[billsbowtie]

[billsbowtie]

[billsbowtie]

[billsbowtie]

[billsbowtie]

[billsbowtie]

[billsbowtie]

[billsbowtie]

blazer doors bad windshield frame bad in corners good for patches only.

[billsbowtie]

[billsbowtie]

[lchall]

Interested in the pedal patch and the area highlighted in the picture shipped to 63303.

Thanks - Chad

[billsbowtie]

ok chad could you measure how far you need from the hole in firewall where the outer heater box use to be. thanks bill

[Grumpy old man]

Hi ,How much for whats left of the Blazer ? Title ?

[lchall]

Originally Posted by billsbowtie

ok chad could you measure how far you need from the hole in firewall where the outer heater box use to be. thanks bill

I'm going to use on my firewall on my 67. Its stamped a little different in this area and I already shaved the heater holes so its a little hard to measure. My engine is in the rear mounting holes and hits the firewall.

Took a pic of my firewall and outlined what I am looking for. This is probably way more than I need to modify, but want to make sure I have more than enough to work with. The lower line is a little hard to see with the angle, but looking for 2-3 inches past the lower stamping line.

[special-K]

Are you selling the bell housing on the Blazer?

[billsbowtie]

Grumpy old man i sent you a pm on whats left of blazer.
lchall there is a cut mark that runs into the piece you need look at # 11 in this tread.
special-K tim i have priced whats left of blazer if he doesn't take it i will let you no something on bell housing.

[lchall]

I see it in the lower right side. I think it'll be ok, I'm not expecting to actually need anywhere near that much. Just figure if I'm going to get a piece cut I might as well make it plenty big. Just need to make sure the rest of it is straight/good. Absolute worst case it would only have a few inches of the cut I'd need to weld up.

[billsbowtie]

ok i will see about getting it off now how about $15.00 for patch and $10.00 shipping with the other patch you wanted if i can fit them together i will take a little off shipping total.

[lchall]

Ok, that sounds good to me.

Thanks - Chad

[billsbowtie]

lchall patch cut pm sent.
anyone else a patch.