OR Modified speed warning rear tin for tach - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**TBONE1964** · 08-13-2015, 07:50 PM

This was a non tach speed warning tin that I began to modify for a tach. The hole was cut using a template from a tach tin. It needs the holes for the mounting screws drilled and some finish work.

$40.00 as is or $60.00 if I finish it, plus shipping.

Thank you for looking,
Tom

**davestrucks** · 08-13-2015, 10:24 PM

I'll take it.

**TBONE1964** · 08-13-2015, 10:29 PM

Quote:

Originally Posted by davestrucks

I'll take it.

I would figure $50.00 shipped plus $10.00 for the brass pin from the other thread so $60.00 total.

I will send you a PM with payment information.

Thank you very much,
Tom

**davestrucks** · 08-13-2015, 10:59 PM

Quote:

Originally Posted by TBONE1964

I would figure $50.00 shipped plus $10.00 for the brass pin from the other thread so $60.00 total.

I will send you a PM with payment information.

Thank you very much,
Tom

Payment sent.

**TBONE1964** · 08-13-2015, 11:04 PM

Quote:

Originally Posted by davestrucks

Payment sent.

Got your payment and address. Parts will ship tomorrow.

Thank you again,
Tom

08-13-2015, 07:50 PM	#1
TBONE1964 Cluster King Join Date: Nov 2012 Location: Junction City, OR Posts: 5,263	Modified speed warning rear tin for tach This was a non tach speed warning tin that I began to modify for a tach. The hole was cut using a template from a tach tin. It needs the holes for the mounting screws drilled and some finish work. $40.00 as is or $60.00 if I finish it, plus shipping. Thank you for looking, Tom Attached Images __________________ Contact me on all of your gauge cluster needs. I specialize in restoration, repair and parts sales for 67-72 Chevy and GMC trucks. email me at tbonegarris@yahoo.com I am also a dealer for Counterpart for gauge cluster parts only. Also see my facebook page, CG&C

08-13-2015, 10:24 PM	#2
davestrucks Senior Member Join Date: Dec 2008 Location: Northglenn Co Posts: 622	Re: Modified speed warning rear tin for tach I'll take it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.