|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-19-2004, 10:01 AM
|
#1 |
|
Registered User
Join Date: Mar 2002
Location: Baton Rouge, Louisiana
Posts: 71
|
offset upper control arm shafts
I'm lowering the front of my '72 Suburban with 2" drop springs. I believe throws off the camber. If this is correct, can the situation be fixed with shims or should I use the offset upper control arm shafts? The pic on the top is the offset one. Thanks.
|
|
|
|
02-19-2004, 11:29 AM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
Is it a C-20 3/4 ton?
__________________
Rest in Peace Ed. Thanks for all the good times. |
|
|
|
|
02-20-2004, 09:35 AM
|
#3 |
|
Registered User
Join Date: Mar 2002
Location: Baton Rouge, Louisiana
Posts: 71
|
It's a 1/2 ton, but it has "2nd design" front end parts which are the same as 3/4 ton front end parts. See my post about it. http://67-72chevytrucks.com/vboard/s...hreadid=90055.
|
|
|
|
|
02-20-2004, 09:59 AM
|
#4 |
|
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
I would get the 1/2 ton uppers and correct concave shims on a 2" drop coil, I believe the offset is for 3" and lower coils but i could be wrong. Whats the company you bought the coils from say to use?
__________________
Rest in Peace Ed. Thanks for all the good times. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
