|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-18-2016, 10:37 PM
|
#1 |
|
Registered User
Join Date: Oct 2005
Location: Lancaster, ca
Posts: 117
|
New engine for project andSpark plug selection
Gang, I just picked up a rebuilt engine for my truck. It had been sitting.
The block # is 3970014(350) and the head #is 3998993( not great heads, could be 1.72 intake or 1.94 intake) the spark plug bores are 14mm "peanut plug. I have a performer manifold and I just rebuilt a 600 performer for it. I will probably run a points distributor with a pertronix ignitor and coil. Whats a good spark plug to use as a starting point R44 etc. Brand does not matter,I usually use AC Champion or autolite Just need an approximate Plug ## As always thank you
__________________
Scott 63 C10 Stepside 230 1bbl Saginaw 3 spd |
|
|
|
07-18-2016, 11:50 PM
|
#2 |
|
Registered User
Join Date: Oct 2005
Location: Lancaster, ca
Posts: 117
|
Re: New engine for project andSpark plug selection
I think the plug will be a champion 3025, It is a 5/8 tapered plug, pre HEI and seems very universal to the SBC
__________________
Scott 63 C10 Stepside 230 1bbl Saginaw 3 spd |
|
|
|
|
07-19-2016, 10:19 AM
|
#3 |
|
Registered User
Join Date: Oct 2005
Location: Lancaster, ca
Posts: 117
|
Re: New engine for project andSpark plug selection
How about a champion RV12YC
__________________
Scott 63 C10 Stepside 230 1bbl Saginaw 3 spd |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
