Help with some wiring. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

dragn91 · 11-19-2016, 07:00 PM

Im trying to go through my truck and clean it up a bit so i tore out the old power door wiring harness because im picking up a new set of manual doors and the wiring was butchered. I came across a couple things idk what they are one was laying on the floor i traced it up to an idiot light for the cluster but idk what one. the other is a aluminum thing hanging under the dash and id like to put it in the right spot. I also ripped out my f'ed up dash and headliner that was deteriorating and falling into my eyes.
http://

http://

Truck is an 85 k30 6.2 thanks for any help

dragn91 · 11-19-2016, 07:33 PM

Also if anyone has a wiring diagram for a dual tank truck for the sending units to the gauge i need to figure out whats up with mine. The switch is m.i.a

Low69CST · 11-20-2016, 09:24 PM

I uploaded what I think is the right diagram. Do a google search and a search here. There is ton of information on the dual tank setup.

mitch1965 · 11-25-2016, 01:05 AM

I believe that the finned aluminum module is your wiper delay controller. It is usually mounted to the lower steering column.

dragn91 · 11-25-2016, 10:32 AM

Ok that makes sence the column has been swapped before i got the truck i noticed a couple things not attached to it right.

11-19-2016, 07:00 PM	#1
dragn91 Registered User Join Date: Aug 2007 Location: charlestown maryland Posts: 272	Help with some wiring. Im trying to go through my truck and clean it up a bit so i tore out the old power door wiring harness because im picking up a new set of manual doors and the wiring was butchered. I came across a couple things idk what they are one was laying on the floor i traced it up to an idiot light for the cluster but idk what one. the other is a aluminum thing hanging under the dash and id like to put it in the right spot. I also ripped out my f'ed up dash and headliner that was deteriorating and falling into my eyes. http:// http:// Truck is an 85 k30 6.2 thanks for any help

11-19-2016, 07:33 PM	#2
dragn91 Registered User Join Date: Aug 2007 Location: charlestown maryland Posts: 272	Re: Help with some wiring. Also if anyone has a wiring diagram for a dual tank truck for the sending units to the gauge i need to figure out whats up with mine. The switch is m.i.a

11-20-2016, 09:24 PM	#3
Low69CST Registered User Join Date: May 2000 Location: Frankfort, Kentucky, USA Posts: 2,163	Re: Help with some wiring. I uploaded what I think is the right diagram. Do a google search and a search here. There is ton of information on the dual tank setup. Attached Images __________________ '69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks

11-25-2016, 01:05 AM	#4
mitch1965 Registered User Join Date: Oct 2004 Location: Fort Collins, Colorado Posts: 376	Re: Help with some wiring. I believe that the finned aluminum module is your wiper delay controller. It is usually mounted to the lower steering column. __________________ '99 K1500 Tahoe, 2dr, barn doors - 350/ 4L60E, 3.73 '01 K2500HD Silverado Ext Cab - 496/ Allison, 4.10

11-25-2016, 10:32 AM	#5
dragn91 Registered User Join Date: Aug 2007 Location: charlestown maryland Posts: 272	Re: Help with some wiring. Ok that makes sence the column has been swapped before i got the truck i noticed a couple things not attached to it right.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.