|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-20-2017, 11:01 AM
|
#1 |
|
Registered User
Join Date: Apr 2017
Location: Bozeman
Posts: 219
|
Pulled axles on a 65 12 bolt question
I pulled my axles last nightvsnd when I pulled the large pin in the rear end (the one that keeps the axles in place) I noticed it was a bear to get out. I've seen guys pull them with magnets. Had to really reef on it with a screwdriver through the hole back and forth la la la. Should I be concerned? Easy visibly bent but I did not take any measurements either. Thanks Charlie
|
|
|
|
04-20-2017, 11:23 AM
|
#2 |
|
Registered User
 
Join Date: Feb 2016
Location: Weatherford Texas
Posts: 306
|
Re: Pulled axles on a 65 12 bolt question
If the crosspin is galled or damaged, they are cheap and easy to get.
Yukon Gear part number YSPXP-038 https://www.yukongear.com/productdet...spx?ProdID=504 Summit has them in stock for 14 bucks. https://www.summitracing.com/parts/yga-33406 |
|
|
|
|
04-20-2017, 11:52 AM
|
#3 |
|
Registered User
Join Date: Apr 2017
Location: Bozeman
Posts: 219
|
Re: Pulled axles on a 65 12 bolt question
Nice thank you very much!
|
|
|
|
|
04-20-2017, 11:53 AM
|
#4 |
|
Registered User
Join Date: Feb 2016
Location: Weatherford Texas
Posts: 306
|
Re: Pulled axles on a 65 12 bolt question
Sure
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
