CPP Crossmember Install - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Dodge68charger · 04-03-2019, 10:01 AM

I Noticed Some Are Mounted On Top Of The Lower Framerail And In Some Pics Their Mounted On Top Of The Lower Frame Rail.

If I Go On The Bottom Will This Make A Huge Differerence With The Angle Of The Transmission??

Also Which Holes Are Correct To Use With a SBC And a Turbo 350?

Thanks Guys
Posted via Mobile Device

**michael bustamante** · 04-04-2019, 12:37 PM

it sits inside the frame. unless youre bagged, then you might want to check your angle and see if mounting the crossmember under the frame will give you a better straight shot when slammed

04-03-2019, 10:01 AM	#1
Dodge68charger Registered User Join Date: Jul 2014 Location: Washington Posts: 535	CPP Crossmember Install I Noticed Some Are Mounted On Top Of The Lower Framerail And In Some Pics Their Mounted On Top Of The Lower Frame Rail. If I Go On The Bottom Will This Make A Huge Differerence With The Angle Of The Transmission?? Also Which Holes Are Correct To Use With a SBC And a Turbo 350? Thanks Guys Posted via Mobile Device

04-04-2019, 12:37 PM	#2
michael bustamante Senior Member Join Date: Sep 2007 Location: Albuquerque NM Posts: 7,862	Re: CPP Crossmember Install it sits inside the frame. unless youre bagged, then you might want to check your angle and see if mounting the crossmember under the frame will give you a better straight shot when slammed __________________ 1967custom

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.