|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-22-2019, 12:40 PM
|
#1 |
|
Registered User
Join Date: Oct 2018
Location: Warsaw IN
Posts: 897
|
I made this for my bell housing.
I am running a hydraulic throwout bearing on my 53 1/2 ton. 292/Tremec TKO 600. I will have 2 hydraulic lines coming out of the hole where the clutch fork would normally go, supply and bleeder lines. I could not find anything that looks nice for this. This can be installed/removed from the outside. It's not perfect but I just used simple tools.
|
|
|
|
04-22-2019, 01:12 PM
|
#2 |
|
Registered User
Join Date: Dec 2000
Location: Boise, Idaho
Posts: 6,029
|
Re: I made this for my bell housing.
Good stuff!
Brian
__________________
1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings" |
|
|
|
|
04-22-2019, 01:24 PM
|
#3 |
|
Post Whore
  
Join Date: May 2015
Location: Alabama
Posts: 14,686
|
Re: I made this for my bell housing.
Nicely done...
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
