|
07-17-2021, 04:43 AM
|
#1 |
|
Registered User
Join Date: Dec 2016
Location: Auckland, New Zealand
Posts: 17
|
Tie rod end help
Hey Guys,
I've got a 69 C10, still got factory 69 Crossmember, have 73-87 upper and lower control arms. I assume the spindles are 73-87 too. Just wondering what tie rod ends I need to get or if there is a way to figure out what's currently being used? Any help much appreciated Cheers |
|
|
|
07-18-2021, 01:28 AM
|
#2 |
|
At the body shop.
Join Date: Aug 2009
Location: Land of fruits and nuts.
Posts: 5,254
|
Re: Tie rod end help
The big end of the taper on my 73 .750 or 3/4"
__________________
" That didnt make it any newer " " Dont antique the equipment " |
|
|
|
|
07-19-2021, 11:05 AM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Re: Tie rod end help
Researching & determining the tie-rod tapers for comparison might help ID what the parts combo is. Most likely it has 71-87 outers if it has disc brakes.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
08-05-2021, 07:11 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Re: Tie rod end help
It is my understanding, that the 71-72 c-10s have the same lower ball joint, as 73-87. They do however have a different taper on the upper ball joint, & outer tie rod end.....if using 73-87 spindles. Longhorn
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
