|
07-19-2004, 05:51 PM
|
#1 |
|
Registered User
 
Join Date: Jun 2004
Location: Midland, MI
Posts: 265
|
Tranny press line ???
Hi all,
Once again I have come to the board for the information that I cant get anywhere else. I am replacing the th350 w/ a 700R4. I scraped the old tranny lines cause I will be installing new. I am also going to install a external tranny cooler inline with the radiatior. Which way should I route the cooler? through the top line or the bottom line. eg. which line is the pressure line? I assume the tranny lines top/top and bottom/bottom on the radiator. Any and all help apprecieated. John |
|
|
|
07-19-2004, 07:20 PM
|
#2 |
|
Registered User
Join Date: Feb 2002
Location: Vacaville, CA
Posts: 2,745
|
Where do you live? If you live in a cold climate you probably want the cooler before the rad if it does not get cold you can get by with placing it after the rad. The bottom line on the trans goes to the rad top line is return.
__________________
 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI |
|
|
|
|
07-19-2004, 07:31 PM
|
#3 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Feed the pressure line to the bottom of the rad....out the top of the rad to the bottom of the cooler......top of the cooler back to the trans. that will keep air out of the system
 crazyL 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
07-19-2004, 11:27 PM
|
#4 |
|
Registered User
Join Date: Jun 2004
Location: Midland, MI
Posts: 265
|
Thanks
John |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
