I was reading this thread earlier looking for information on my wiper motor - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Thealien** · 12-07-2021, 07:29 PM

Here is a link to that thread...

https://67-72chevytrucks.com/vboard/...d.php?t=816417

Wiper Motor Install (Grommets, Seals, Timing Marks)

I was reading this thread earlier looking for information on my wiper motor. I see the discussion of the ground on one of the rubber isolators. You do not have to drill any rivets. Push the metal center out from the bottom. This will free the ground strap and you will be able to replace the rubber bushing. I believe GMC Pauls mentioned this in his post. Here is a picture that may help others.

12-07-2021, 07:29 PM	#1
Thealien Senior Member Join Date: Jun 2007 Location: Pine Ridge Florida Posts: 4,134	I was reading this thread earlier looking for information on my wiper motor Here is a link to that thread... https://67-72chevytrucks.com/vboard/...d.php?t=816417 Wiper Motor Install (Grommets, Seals, Timing Marks) I was reading this thread earlier looking for information on my wiper motor. I see the discussion of the ground on one of the rubber isolators. You do not have to drill any rivets. Push the metal center out from the bottom. This will free the ground strap and you will be able to replace the rubber bushing. I believe GMC Pauls mentioned this in his post. Here is a picture that may help others. __________________ Click on my Not really a build thread, yet NOT SO RUST FREE RUST FREE BLAZER LS ENGINE SWAP INFORMATION THREAD BOLT RESTORATIONS 4l60 to an NP205

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.