|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-30-2004, 06:33 PM
|
#1 |
|
Registered User
Join Date: Jan 2004
Location: San Diego
Posts: 25
|
looking for bed wood tips.
Am about to start bed wood replacement (oak w/stainless strips and hardware). Any hints or good write-ups you know of to avoid any pitfalls? Also, am trying to decide on a finish. I've heard a marine grade varnish or polyurethane is a good choice, but was also considering tung oil, knowing I would have to reapply every so often. I'm a little worried that after a few years, a varnish would fade or peel, requiring a tear down, strip and re-finish. What do ya think?
Thanks! Dan 
__________________
'68 Chevy LWB Fleetside 3/4T, 454/T400, PS, PB, PL, HEI, Dynomax Ceramic/Flowmasters, Oak/Stainless Steel bed, 90% Rest. '97 Lexus LX450 (FZJ80 Land Cruiser in disguise) Factory F&R Lockers '97 Camry DD w/Cleveland Browns sticker |
|
|
|
07-30-2004, 07:00 PM
|
#2 |
|
Registered User
 
Join Date: Feb 2001
Location: East Central, MO
Posts: 11,336
|
Nothing will work very well if it sits outside in the weather (sun)......... Mine did and I bought one of those little sanders that I could sand between the rails with easily. Redone them every Spring.
|
|
|
|
|
07-30-2004, 08:22 PM
|
#3 |
|
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
You have PM on tips.
__________________
Rest in Peace Ed. Thanks for all the good times. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
