Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
06-29-2024, 10:03 AM | #1 |
Registered User
Join Date: Dec 2017
Location: Missouri
Posts: 269
|
Edelbrock carb bracket recommendations
I just installed an Edelbrock Performer #1406 carb and Edelbrock EPS intake # 2701 onto my 1977 K10 that has a 400sbc and 4 speed trans. It looks like I'll need throttle cable stud kit # 8009, but I'm not sure on the T cable bracket. I've used Edelbrock T cable brackets in the past on a few Pontiacs, always had to bend or weld them to fit. Does anyone make a good fitting,simple bracket that the factory cable will snap into?
|
06-29-2024, 03:07 PM | #2 |
Registered User
Join Date: Dec 2017
Location: Missouri
Posts: 269
|
Re: Edelbrock carb bracket recommendations
I think I found something that will work, JEGS # 555 157313 I'll get one ordered and post results.
|
06-29-2024, 10:18 PM | #3 |
Registered User
Join Date: Dec 2017
Location: Elkhart, Texas
Posts: 1,649
|
Re: Edelbrock carb bracket recommendations
|
06-30-2024, 08:50 AM | #4 |
Registered User
Join Date: Dec 2017
Location: Missouri
Posts: 269
|
Re: Edelbrock carb bracket recommendations
That'll be my back up if the Jeg's part doesn't work, years ago, I bought similar brackets like that from Summit and Edelbrock, they were flimsy and really didn't fit all that well. Thanks!
|
06-30-2024, 10:13 AM | #5 |
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,542
|
Re: Edelbrock carb bracket recommendations
They’re still flimsy.
I’ve used ones like this. Much stronger. https://www.summitracing.com/parts/s...yABEgKYGfD_BwE |
07-02-2024, 01:24 AM | #6 |
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,487
|
Re: Edelbrock carb bracket recommendations
i have yet to get anything from edelbrock lately that I don't have to cut, weld, and modify to get it correct. As much as I despise 700 transmissions I was stuck with one in the shop that needed a cable installed. Took me 3-4 hours with servicing the trans and modifying the 'linkage kit' to get the geometry correct so it would shift right
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|