![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
![]() Join Date: Jul 2002
Location: Oak Harbor, WA
Posts: 709
|
2 part roller cam question
Can a moderator move this to the enginepage?
Hey all. I have a 1995 tbi motor that is flat tappet, but has the provisions for the factory roller set up. Opinions aside on why you would or wouldn't, is it physically possible to use a retrofit roller cam in that factory roller block? I could skip the cam retainer and use a wear plate with a thrust button and original timing gear style (gen 1)? I could also use the spider plate and dog bones and factory style indexed roller lifters? Which leads me to which rollers are people using? 6500 rpm and under. Thanks for your time. Pat
__________________
Patch Last edited by Patch; 07-07-2024 at 12:07 AM. |
![]() |
![]() |
![]() |
#2 | |
Registered User
![]() Join Date: May 2006
Location: Yucaipa, Calif.
Posts: 786
|
Re: 2 part roller cam question
Quote:
__________________
1989 K1500 Chev. EC Original owner; some of the aftermarket parts I've installed are Borla headers, Hypertech chip, Edelbrock water pump, and a Stillen rear disc brake conversion kit. 2009 Hummer H3T 3.7L 5M (sold) 1997 K2500 Chev. EC 7.4L/ 4L80E 2018 Dodge Ram 2500 HD R/C |
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|