Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-02-2024, 05:16 PM | #1 |
Registered User
Join Date: Aug 2021
Location: Armstrong BC
Posts: 52
|
Brake line slack holder.
Hey fellas, hoping this helps out some other fellas who run air bags and have the same issue of the long brake lines almost getting caught between the upper control arm and the cross member. I used 4 M8 rivnuts, two 3/8 rubber clamps along with M8x16 bolts and some locktite for added security. These springs had the perfect ID for the M8 rivnut.
uxcell 3D Printer Die Spring, 20mm OD 150mm Long 2pcs Spiral Stamping Light Load Compression Mould Die Springs for 3D Printer Electric Part, Yellow https://a.co/d/4bx6mKz Rivnuts on the inside of both ends of the spring. then drill a hole just big enough in the upper control arm to fit a M8 bolt through. rest is self evident. works really well. |
09-04-2024, 11:04 PM | #2 |
Senior Member
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,488
|
Re: Brake line slack holder.
That's a neat trick. Thanks for sharing!
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|