anyone that fabricates

[mrwilmoth]

I need a stereo cover plate that fits in flush into where the factory stereo goes, it needs to be flush with the dash and attached by two screws. can someone do this for me? thanks

btw my current dash is cut so I cannot use a regular radio delete plate.

[Putter]

SO, in so many words, you need an OVERSIZED radio delete? Can you sketch it out for me?? Do you want it flush with the recessed part....or flush with the non-recessed part (like the remainder of the dash)????

[mrwilmoth]

flush like the remainder of the dash.

[Putter]

So, are you wanting to delete it....or be able to install a radio? I have an uncut center section if you need it from a donor dash....or, I can make a delete with the raised rib around it (so it looks almost like a stock piece) that will sit on the 'remainder' section of the dash, fasten from the back, and be slightly larger than the recess.

[mrwilmoth]

ya thats what I want. something that covers it and looks like the factory. thanks alot
>
>or, I can make a delete with the raised rib around it (so it looks almost like a >stock piece) that will sit on the 'remainder' section of the dash, fasten from the >back, and be slightly larger than the recess.

[Putter]

Any chance in the world that you can get a picture of your dash, so I can SEE how much is actually cut out & guesstimate where the fasteners should be???