|
10-29-2005, 11:27 AM
|
#1 |
|
Registered User
 
Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
car pattern 5 4 /34
well i was looking thruogh a parts book to find car rotors to replace my 71 5 on 5 rotors when i seen that the chevy 71-73 g10 van came out with disc 5 on 4 3/4 pattern and drums or disc on the back with the same pattern so i am going to look at the rotors today at the parts stoor to see if they are a direct replacement and i will also be getting those rear drums and new axles out back. 5 on 4 3/4 is much easier to find wheels for. bet you did not know 5on5 drag lites wont fit the front of a chevy with out the rotor center being turned a little just found out yesterday. the hole in the center of the wheel is to small.
|
|
|
|
10-29-2005, 02:05 PM
|
#2 |
|
Registered User
Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
Re: car pattern 5 4 /34
the van rotors wont fit the truck spindle but you could use a complete van set up spindle and all to accomplish this. im going to use the 5 on 5 drag lite and i will have my 71 rotor center turned about 1/8 of and inch so the wheel will fit
|
|
|
|
|
10-29-2005, 02:19 PM
|
#3 | |
|
Registered User
Join Date: Oct 2002
Location: S.W. Michigan
Posts: 403
|
Re: car pattern 5 4 /34
Quote:
__________________
Good Judgment comes from experience. Most experience comes from bad judgment. |
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
