|
07-30-2006, 05:29 PM
|
#1 |
|
Registered User
Join Date: Apr 2006
Location: nc
Posts: 10
|
bellhousing swap
hey yall i am new to the board.i have a 1967 chevy c10 long bed, it has a 250 inliner with a factory 3 speed tranny, im putting a 327 in it where could i find a v8 bellhousing for this tranny. i have looked in all the junkyards and tried all of my connections and no luck finding one. i didnt think it would be this hard finding one, maybe nobody wants to sell em idk?? thanks in advance for any advice
Last edited by 67greenmachine; 07-30-2006 at 05:36 PM. |
|
|
|
07-30-2006, 05:36 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Re: bellhousing swap
No need to swap....the I6 bell will bolt right on the 327. You can also use the flywheel/clutch/pressure plate, but it will be a 10 1/2" setup, vs the 11" V8 pcs.......
 L
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
07-30-2006, 05:37 PM
|
#3 |
|
Registered User
Join Date: Apr 2006
Location: nc
Posts: 10
|
Re: bellhousing swap
ok i was just wondering cause iv always messed with v8's never fooled with a inliner so thanks for the advice..
|
|
|
|
|
07-30-2006, 05:38 PM
|
#4 |
|
RIP Mr Ron
 
Join Date: Dec 2005
Location: Big Sandy, Tn. 38221
Posts: 8,150
|
Re: bellhousing swap
I think you can use the one you got. It should be the same.
__________________
Ron (Mr Round Tuit)  Be kinder than necessary, for everyone you meet is fighting some kind of battle TN Message Forum TN Facebook Group SETN Truck Show My Photobucket |
|
|
|
|
07-30-2006, 05:41 PM
|
#5 |
|
RIP Mr Ron
Join Date: Dec 2005
Location: Big Sandy, Tn. 38221
Posts: 8,150
|
Re: bellhousing swap
O yeah welcome to the board from West Tennessee. Good luck with your engine swap.
__________________
Ron (Mr Round Tuit) Be kinder than necessary, for everyone you meet is fighting some kind of battle TN Message Forum TN Facebook Group SETN Truck Show My Photobucket |
|
|
|
|
07-30-2006, 05:43 PM
|
#6 |
|
Registered User
Join Date: Apr 2006
Location: nc
Posts: 10
|
Re: bellhousing swap
appreciate it!!
|
|
|
|
|
07-30-2006, 07:36 PM
|
#7 |
|
Senior Moment
Join Date: Mar 2002
Location: Pittsburg Ca
Posts: 4,193
|
Re: bellhousing swap
The clutch Z bar will be differant for the V8
__________________
1970 CST LS 1 6 speed Ford 9 inch Detroit Tru Track, Dakota Didgital, Vintage Air, QA1 Coil Overs Front & Rear Lots of FUN 2013 GMC PU, Oldest Son 71 GMC LWB. QA1 Suspension, Angry SB. Youngest Son 2017 Toyota SUV Daughters car 2018 Traverse , Wife’s Ride Pittsburg Ca 94565 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
