|
12-08-2006, 04:22 PM
|
#1 |
|
Registered User
Join Date: May 2003
Location: MOORE, OK
Posts: 146
|
Welding Patch Panels
I Know When You Weld In Patch Panels That You Spot Weld It Slowly And Work You Way Around. I Am Just Doing A Small Piece On The Front Side Area Of The Cab.(behind The Back Of The Fender) I Cut A Piece Of Metal And Spot Welded It, But When I Ground It Down You Could See Some Really Small Holes Or Kinda Like A Small Crack Where The Patch Is. I Know The Crack Is Not Normal, But Should You Be Able To Make It Look Just Like One Piece Of Metal Or Should You Use Like A Sealer Or Filler To Make It Solid?
|
|
|
|
12-08-2006, 06:19 PM
|
#2 |
|
Registered User
Join Date: Nov 2005
Location: Rouleau, Saskatchewan
Posts: 87
|
Re: Welding Patch Panels
I would recomend doing some more welding and grinding to clean it up. I am assuming that you didn't get good enough penetration to fill the gap. The small holes were caused by the flux splaterring or just missed a little bit.
__________________
1946 Chevy ton truck 1972 Chev C30 1975 Scottsdale C10 |
|
|
|
|
12-08-2006, 09:58 PM
|
#3 |
|
Registered User
Join Date: Nov 2001
Location: Concord, NC
Posts: 2,489
|
Re: Welding Patch Panels
Post some pics......
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
