|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-15-2007, 04:36 PM
|
#1 |
|
Registered User
Join Date: Feb 2007
Location: Westfield, Tioga County) Pennsylvania
Posts: 113
|
Sheetmetal for Gas Fill Neck Area Exist?
Did not see this topic listed anwhere... The sheet metal around the gas filler neck om my 68 panel has some rot around it. PO had spread some putty around the area - I would like to replace the area with new steel. It's surely an odd shape to reproduce. I previously purchased a entire suburban side to cut out just that area to replace it with but, just can't bring myself to cut up a nice side if one might be available. May post the side for sale at a later date. Any suggestions?
__________________
Ironhead Mike '68 Panel 402BB '84 Shortbox 4X4 '85 Blazer '97 Silverado Ext. Cab |
|
|
|
02-15-2007, 07:21 PM
|
#2 |
|
Out draggin'
Join Date: Jan 2004
Location: Pitman,NJ
Posts: 1,574
|
Re: Sheetmetal for Gas Fill Neck Area Exist?
Well, Maybe we can help each other out... I have a 71 & a 72 burb, both with good gas fill areas... The 72 is a parts truck & the 71 is getting the filler neck replaced with a gas door so I will have 2 available. I may be interested in the quarter panel depending on how nice it is... Interested in talking it over, send me a PM...
 L8R - Joe
__________________
91 GMC Xcab LB-Bags/bd/caddy clip SOLD 72 C10 Cheyenne Super LWB SOLD 92 GMC K1500 Burb 72 C10 Burb (ex. Cheesewagon)SOLD 72 C20 Burb parts truck 71 C10 Burb "project" |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
