|
03-02-2007, 02:03 PM
|
#1 |
|
Senior Member
Join Date: Mar 2003
Location: St robert Mo
Posts: 2,001
|
Mech Temp guage
Is there anyway to remove one without pulling the sender out of the intake? Can the tube be removed from the gauge and then replaced?
__________________
1968 c10 lowered 3" 4" 355/Th400 built by Hatfield racing in joplin MO |
|
|
|
03-02-2007, 02:48 PM
|
#2 |
|
Registered User
Join Date: Apr 2004
Location: N.E. MO
Posts: 1,749
|
Re: Mech Temp guage
Nope. That tube is filled with somethin and if you bend it too much or remove it from the guage or the "sensor" end the gauge will be junk.
My autometer in my S-10 finally gave up during the last engine swap because of being "rearanged" too many times.
__________________
72 C20 4X4 454 4 speed 89 Trans Am (was) 305 TPI 700r4 93 C1500 2wd Extended cab 350 700r4 98 Sonoma (TPI outa the Trans Am) 03 Yamaha 660 Raptor 03/04 660 Raptor 07 700 Raptor 85 Honda Odyssey |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
