![]() |
![]() |
#1 |
Registered User
Join Date: May 2002
Location: memphis Tn USA
Posts: 24
|
![]()
I have a 69 chevy swb 350 engine 350 trans. I installed a new speedometer cable when i drive it the speedometer bounces up and down. is this normal or is it something i did or didnt do ? Thanks for all of the welcomes.
|
![]() |
![]() |
![]() |
#2 |
Account Suspended
Join Date: May 2002
Location: Olathe, Kansas
Posts: 929
|
![]()
Assuming you installed a new housing with the cable?
Even if you installed with a new cable/housing it will still need lubing. Nice packet of graphite lube does the trick. The reason its bouncing is there is too much friction at some point (ie old grease in housing, binding or kinked housing) ------------------ '71 LWB Special options? Yes, RUST... Need some? |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
![]()
The speedometer needle should not bounce. The majority of the time it is caused by the cable as mentioned. The cable should be well lubricated and the connections on both ends should be tight. I would make sure that the inner cable ends are chamferred. Sometimes the ends are rough and this can cause a problem. Any kinking of the cable will cause the problem, so look it over carefully. If you have eliminated all problems with the cable and it still bounces, I would check the gear out. Last item to look at is the speedometer itself, which is practically never the problem.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
![]() |
![]() |
![]() |
Bookmarks |
|
|