carb dual fuel feed

[tx71smallblock]

would a dual fuel feed on a carb make it run too fast?
as in getting to much fuel?

[cdowns]

not if your pressure regulator is set and working properly/and your floats are set to specs

[tx71smallblock]

its just an edelbrock 650, no regulator i dont think. but i put a duel feed set up on it cause it looks good and now its ideling at 1000 with the idel screw backed all the way out

[cdowns]

never heard of a dual feed edelbrock carb would like to see pictures

[tx71smallblock]

here u go...

[wzuke]

Make sure your choke is set and working correctly.

[FRENCHBLUE72]

Ok thats the 1st time I have ever seen that ....... Glad you had a pic cause I would have called b.s. on that ??

[RyanG]

Not sure if this will help but I had the same problem.....I checked the timing and I was at like 16 deg BTDC.....I fixed that and all of a sudden I had full opertion of the idle screw. I am not sure why it worked like that but it did. Maybe the gremlins climbed out when I walked away from it. J/K

Just a thought.

[tx71smallblock]

i noticed that to but when i fixed it it wont start back up afterward.

[tx71smallblock]

so i put it back the way it was (16* btdc)

[tx71smallblock]

i also didnt know the choke controled anything after start up. mine is elec. but not hooked up will that help with the fast idel and not starting when properly timed?

[TravisH]

I'm no carb expert but the edelbrock isn't 'dual feed' like a holley, its meant to be set up one side or the other, theres just two ports to make plumbing easier.

Whether that has anything to do with your problem I can't say. The pressure should be the same just more volume

[tx71smallblock]

travisH, its not acually being feed from two full sources, its fed from one line into a spliter that directs the fuel to both sides

[scooter122983]

Make sute the choke is wired to a full 12 volt source because if it is not getting the proper voltage then it will run at fast idle with the choke closed.

[tx71smallblock]

where is a good place to wire it?

[berencam]

you can run it with the same wire that runs your hei dizzy....

[tx71smallblock]

so the wire that runs power to the dist. cap marked "batt" or "battery" is a good place.

[berencam]

mmm i think that isnt a ignition only wire.... that being said im not the one to be asking on the wiring. But i do know it needs to be a ignition only wire not always on.

[tx71smallblock]

what did u mean by "the wire that runs your hei dizzy" ?

[berencam]

the positive one that is hot when you turn the key to on...

[tx71smallblock]

so like the ones i used to give my tach and radio power?

[Billla]

I think there's something's fundamentally wrong here; I doubt the carb is dual feed; it's set up to feed from one side OR the other. If this is the ONLY change you made that caused the problem, then I wouldn't look elsewhere - I'd swap it back and see if it goes away.

[berencam]

yes, but i would like someone else to chime in, i would hate to ruin your electric carb.

[tx71smallblock]

the dual feed kit is an edelbrock product, its made for that carb. i did take it off the other day and run a single line the carb but it still ran at exactly the same rpm.

[Billla]

Learn something new every day

So - did this problem start suddenly or it's always been there? Anything else change when it started? Did it happen suddenly or over time? The key questions are what changed and when...