|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-10-2008, 12:17 PM
|
#1 |
|
Registered User
Join Date: Dec 2007
Location: Glendale, AZ
Posts: 156
|
LS motor in 4WD frame! Who has done it?
I am now on my third set of motor plates and am still not having any luck with the install. The motor is a 6.0L LQ9 truck motor and the vehicle is a 72 Chevy K-10 truck. The last set were S&P plates and after numerous tries, and calls to Mark who insisted that they fit, the plates were not even close!!! I called and spoke with Larry and Mark at length and they both finally agreed that the plates must not fit with 4WD frames. I sent numerous pictures of the frame and the issue and we were still not able to come to a favorable conclusion.
I am now sending the plates back and we are back at square 1... Where now? |
|
|
|
06-10-2008, 06:19 PM
|
#2 |
|
I'm a poor spectator
Join Date: Aug 2006
Location: San Antonio, Tx
Posts: 2,287
|
Re: LS motor in 4WD frame! Who has done it?
I can't remember his name but there's a guy with a really nice yellow blazer on the blazer forum who has a supercharged 6.0 in his blazer. Post something there.
__________________
2006 Jeep Unlimited IMPACT ORANGE 1993 Chevy 2500 4x4 ExCab LWB 454/NV4500 Tow rig  1977 Ford F100 2x4 LWB 1st truck I owned, still have it!!!  1979 Ford F150 4x4 SWB Built Ford Tough!!!  1971 Chevy Blazer 350 / SM465 / NP205 UNDER CONSTRUCTION Soon to have a LQ4 6.0!!! |
|
|
|
|
06-10-2008, 06:51 PM
|
#3 |
|
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
|
Re: LS motor in 4WD frame! Who has done it?
that is billyjo, IIRC
|
|
|
|
|
06-10-2008, 10:33 PM
|
#4 |
|
Registered User
Join Date: Aug 2005
Location: Santa Cruz, CA
Posts: 61
|
Re: LS motor in 4WD frame! Who has done it?
I just had the guys at pacific fabrication put a 6.0 in my 72 4x4 Burb and they mocked up a crossmember that they are going to sell soon, they are the only guys I could find that have done 4x swaps in 67-72 4x (locally)
__________________
72 K20 Suburban 6.0L, 4L80, 4Wheel Disc Brakes, Hydroboost, In a Million Pieces(edit) A little closer to done |
|
|
|
|
06-11-2008, 09:03 PM
|
#5 | |
|
I'm a poor spectator
Join Date: Aug 2006
Location: San Antonio, Tx
Posts: 2,287
|
Re: LS motor in 4WD frame! Who has done it?
Quote:
__________________
2006 Jeep Unlimited IMPACT ORANGE 1993 Chevy 2500 4x4 ExCab LWB 454/NV4500 Tow rig 1977 Ford F100 2x4 LWB 1st truck I owned, still have it!!! 1979 Ford F150 4x4 SWB Built Ford Tough!!! 1971 Chevy Blazer 350 / SM465 / NP205 UNDER CONSTRUCTION Soon to have a LQ4 6.0!!! |
|
|
|
|
|
06-12-2008, 03:05 PM
|
#6 |
|
Registered User
Join Date: Dec 2007
Location: Glendale, AZ
Posts: 156
|
Re: LS motor in 4WD frame! Who has done it?
Yes, I emailed am PM'd that Billyjo. but he has not posted on the board since 2/08. Maybe that hotrod truck got him locked u...
|
|
|
|
|
06-12-2008, 04:02 PM
|
#7 |
|
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
|
Re: LS motor in 4WD frame! Who has done it?
he frequents LS1tech too, same name also.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
