|
08-03-2008, 08:41 PM
|
#1 |
|
The start of the $ pit!
Join Date: Jul 2005
Location: garland, Tx
Posts: 153
|
Oil pan removal
I am attempting to remove the oil pan in the 68. it has a 327.
I thought I could remove the pan without raising the engine but have found that I cannot. What is the secret and can it be down without dropping the transmission? |
|
|
|
08-03-2008, 09:12 PM
|
#2 |
|
Senior Member
Join Date: Apr 2000
Location: Orlando, FL
Posts: 1,076
|
Re: Oil pan removal
I've done a 400 SBC in a 4x4 and a 402 BBC in a 2x4. Can't say it was fun. Changed the rear main seal in both. Lifted the motor and tranny just enough to clear the front crossmember.
__________________
............................................................ 68 Chevy CST SWB w/LS1, carb & 700r4. Golden Anniversary clone with a few improvements. Last edited by Vince M; 08-03-2008 at 09:13 PM. Reason: wrong wording |
|
|
|
|
08-03-2008, 11:43 PM
|
#3 |
|
LET'S GO RACIN'
 
Join Date: Oct 2007
Location: SALINA,KS
Posts: 1,212
|
Re: Oil pan removal
Yes, it can be done without dropping tranny. Like said above, just lift motor and tranny up then pull it out. Watch the timing chain cover when you pull it, they are sealed to each other.
__________________
Daren 04 Chevy Extend cab 2500HD 6.0 Liter 4x4 71 CHEVY 3/4 4X4 402 BB, th400/np205, dana44/eaton ho52 w/4:10-TOY  Rip El Jay RIP BOBBO'S MOM |
|
|
|
|
08-04-2008, 06:49 AM
|
#4 |
|
Senior Member
Join Date: Apr 2005
Location: Joppa, Maryland
Posts: 4,408
|
Re: Oil pan removal
here ya go...... http://67-72chevytrucks.com/vboard/s...91#post1487791
__________________
1997 GMC Sierra Ext 1965 Mustang |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
