Steering column to gearbox, pics?

[NWD02]

I need to see some pictures of the steering columns to the gearbox. Will the same piece work off a 3spd column and an automatic tilt?

[Sport/Truck]

This is my auto non tilt column. Hope it helps.
I just realized don't have a complete photo after I redid my steering column.
s/t

Here's one after I painted everything.

[NWD02]

It's helping a little. One from in the cab would be a big help too. I'm trying to figure out what I'm missing to install the column.

[Sport/Truck]

I don't have one in the cab. But it has only one clamp IIRC.
s/t

[NWD02]

So inside the cab there's only one other mount right?

[petey-pablo]

I thought they was 3 clamps inside 2 under the dash and 1 other closer to the cluster that clamps the rubber part of the colum I may be wrong it might just be 1 under the dash and one to hold the rubber ... But Who knows I Still haven't mouted mine Niether on that end, maybe I will do it tomorrow...

Subscribed to Thread JIK I'm wrong.....I might need this info too ...

[NWD02]

There's the one on the firewall (strap around the column), the ring inside the firewall (under dash), one towards the top of the column under dash (i think) and the thin plate that is directly under the rubber near the gauge cluster...

[dwcsr]

I just shortened my 72 column and there is one band clamp at the firewall under the master and one strap at the cluster.

[70GMCer]

I use all the brackets from my 3spd manual to auto tilt swap.

[NWD02]

Did you use the same shaft connecting the column to the gearbox?

[70GMCer]

Originally Posted by NWD02

Did you use the same shaft connecting the column to the gearbox?

No...the column shaft is totally different on a tilt.....The shaft that the rag joint connects to, I'm not sure if the tilt one is the same or not as my tilt was complete including both shafts. I just used the mounting brackets & rag joint from the manual column.

[NWD02]

Ok, thanks, that helps a lot.

[NWD02]

Ok, here's a little more information on what I'm doing. I'm trying to convert my 67 from 3spd to auto tilt. I took the truck apart roughly a year ago and trying to figure out the brackets and what goes where. I think I just figured out the upper bracket has the rubber squares on it where the brake and clutch pedals used to rest. I'm thinking it might be a different bracket for 68-72 since the e-brake changed. I've found the lower(outer firewall bracket. I have another piece that I think goes with the upper. It's flat partial rounded strip. Any help would greatly be appreciated.

[NWD02]

70GMCER, do you have a picture of the upper bracket and how it's mounted? Thanks again.

[mbgmike]

I wood make it out of wood. Sorry Nick