![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Feb 2008
Location: Surprise, Ariz.
Posts: 186
|
![]()
Recently i installed a reman starter/solenoid combo. Have the wires attached
correctly (3) wires. When i turn the key i don't hear anything. Could this be an ignition problem. The battery is fully charged. please advise ![]() thanks frankyjoeyt |
![]() |
![]() |
![]() |
#2 |
the pollock
Join Date: May 2008
Location: abilene, texas
Posts: 4,423
|
Re: trouble shooting elec.
check with a multimeter your positive terminals for power...
if they both get power twhen they are supposed to then the starter is bad.. it is highly unliely you messed up anything after replacing the starter.. especially if you disconnected the battery as required...
__________________
Jack of ALL trades, Master of none.. (but one... procrastination) Army vet 02-08 RIP El Jay! Miss you brother! http://67-72chevytrucks.com/vboard/s...d.php?t=343538 http://67-72chevytrucks.com/vboard/s...d.php?t=386042 |
![]() |
![]() |
![]() |
#3 |
Cheyenne Super
Join Date: Nov 2008
Location: Dallas Texas
Posts: 545
|
Re: trouble shooting elec.
Standard shift trans? maybe bad clutch safety switch.
Auto trans, bad neutral safety switch. |
![]() |
![]() |
![]() |
#4 |
Junior Member
Join Date: Feb 2005
Location: Huntingburg IN
Posts: 620
|
Re: trouble shooting elec.
sounds to me like you have your solenoid wire on the wrong terminal...
|
![]() |
![]() |
![]() |
Bookmarks |
|
|