|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-08-2009, 08:33 PM
|
#1 |
|
Registered User
Join Date: Feb 2007
Location: Cali Central Coast
Posts: 5,191
|
JY sway bar question -
I got this sway bar off a 1-ton at the JY - it's a 1-1/4" bar, but my question is, it has a lot of scaling/rust on it, and I wanted to clean it up before I installed it. If I clean off the scaling, will it make the urethane bushings fit too loosely? Has anyone ever done this before?
__________________
'67 SWB Fleetside ZZ4/350/Tremec 5-speed/4link/Scott's IFS - and fun as heck! SOLD  Click here to support the board Philippians 4: 6-7 |
|
|
|
06-08-2009, 08:50 PM
|
#2 |
|
Dave's not here, man
Join Date: Jun 2004
Location: Winder, Georgia
Posts: 2,000
|
Re: JY sway bar question -
Mine was in similar condition when I got it and I hit it with the wire wheel attachment on my grinder. I didn't cause any installation problems. I think you should be fine.
__________________
- 2014 VW Jetta - 2015 VW Jetta - 1966 Ford F-250 |
|
|
|
|
06-08-2009, 09:33 PM
|
#3 | |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: JY sway bar question -
Quote:
 I've seen those things rust in 1/2! you can sand blast it, sand it with a sander, hit it with a wire wheel or a grinder.... there's not enough there to matter. |
|
|
|
|
|
06-08-2009, 09:41 PM
|
#4 |
|
Registered User
Join Date: Feb 2007
Location: Cali Central Coast
Posts: 5,191
|
Re: JY sway bar question -
Cool, thanks guys, I just didn't want those bushings to be sliding around too much.
__________________
'67 SWB Fleetside ZZ4/350/Tremec 5-speed/4link/Scott's IFS - and fun as heck! SOLD Click here to support the board Philippians 4: 6-7 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
