|
07-15-2009, 06:54 AM
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: swindon, england
Posts: 290
|
Help needed
I have purchased a brake booster kit from CPP which has been sent with no instructions, when fitting this brake booster kit the two rubber gaitors dont fitt, ? are they needed ? as when in place they are longer than the brackets that bolt to the bulkhead,
I have tried to email cpp but no reply ?? I have tried to open the cpp tec article but it wont open. Has anyone fitted one of these, 63 c10 |
|
|
|
07-15-2009, 11:23 PM
|
#2 | |
|
Senior Member
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
|
Re: Help needed
Quote:
__________________
www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! |
|
|
|
|
|
07-16-2009, 03:14 AM
|
#3 |
|
Registered User
Join Date: Apr 2009
Location: swindon, england
Posts: 290
|
Re: Help needed
cannot seem to post with a picture, i have tried to notify the forum but no luck ?
|
|
|
|
|
07-16-2009, 06:14 AM
|
#4 |
|
Registered User
Join Date: Feb 2006
Location: Smyrna, Ga
Posts: 1,647
|
Re: Help needed
make sure you resize the pics.
go to the FAQ forum, there are How-To's on posting pics. |
|
|
|
|
07-18-2009, 03:42 AM
|
#5 |
|
Registered User
Join Date: Apr 2009
Location: swindon, england
Posts: 290
|
Re: Help needed
I ground the hole in the bulkhead out by 4mm all round, fits now,
I spoke to cpp about this as it is sold as a direct replacement part, this was my reply, You just gotta push it in harder man, !!!!!!!!!!!!!!!! Now i have another problem, fitting brake pipes to the proportioning valve, with the fittings that i have i only have two full turns on the fitting & this is without the thicknessof the brake pipe end, As cpp gave me no instructions i need to know what the threads are, does anyone know, I have not contacted cpp for this problem as you can see from there last reply, |
|
|
|
|
07-18-2009, 01:18 PM
|
#6 | |
|
Seņor Member
Join Date: May 2002
Location: Edge of the world
Posts: 5,367
|
Re: Help needed
Quote:
 Note to all: Please consider perusing the Review board before making purchases. There are some vendors who consistently outperform others in product quality, price, and customer service.
__________________
|
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
