|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-31-2010, 07:28 PM
|
#1 |
|
Registered User
Join Date: Jan 2007
Location: vernon b.c.
Posts: 3,022
|
new rotor & bearings install ?
I have a 80 2 wheel dr. and had a semi bad rotor so decided to change both and bearings anyway,but I have to go up north[,400 miles] I have a couple days till I leave, so will they seat a little more,and should I re-check the pre-load when the truck is hot or cold.I get paranoid when I do something just before I leave.First 100 miles is, whats that noise.I,ll bring my laptop and someone will tow me home before a cougar gets me, HA
|
|
|
|
05-31-2010, 08:06 PM
|
#2 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: new rotor & bearings install ?
There is no reason the have to re-check them. If they were right in the first place, they will be fine.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
06-01-2010, 10:35 AM
|
#3 |
|
Registered User
Join Date: Jan 2007
Location: vernon b.c.
Posts: 3,022
|
Re: new rotor & bearings install ?
well I tighten the nut as I spun the rotor until I starting getting snug then backed it off until loose then tightened by hand and then went to the next cotter pin hole
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
