TX WTB factory spark plug wire heat shields for a 350 small block w/ ram horn manifolds

[WIDESIDE72]

I need a full set of factory spark plug wire heat shields for a 350 small block and factory ram horn manifolds. I need both sides. This is just another downfall to building a truck that had no engine... Please post a photo or two, and include your price along with shipping cost to Leander TX 78641

[67gmcstepside]

Originally Posted by WIDESIDE72

I need a full set of factory spark plug wire heat shields for a 350 small block and factory ram horn manifolds. I need both sides. This is just another downfall to building a truck that had no engine... Please post a photo or two, and include your price along with shipping cost to Leander TX 78641

I feel your pain!! "All the parts are in the boxes" The PO must still have a few then.

[sharpie1972]

I'll be pulling a set this weekend and can post pics then if you haven't already found a set. Sharpie

[WIDESIDE72]

Originally Posted by sharpie1972

I'll be pulling a set this weekend and can post pics then if you haven't already found a set. Sharpie

Let me know what you find. I appreciate it.

[C10-Driver]

Would these be of any use for you? I got them with some other parts I bought and they are just sitting in my garage collecting dust. From what I have found, it says they are "SPARK PLUG SHIELD, LH front or RH rear, fits all small block engine only". If you are interested, make me an offer... I have no use for them.

http://67-72chevytrucks.com/vboard/s...d.php?t=415898

BTW, I have no idea if they are even correct for our trucks. They might be for a car... I just haven't been able to find out much about them.

[C10-Driver]

You can probably forget my previous thread. I think I found that they are for Impala, Caprice, Bel Air & Biscayne. They came with a "lot" of truck parts that I bought so I just assumed they were for a truck. You know what happens when we assume.

[WIDESIDE72]

Originally Posted by C10-Driver

Would these be of any use for you? I got them with some other parts I bought and they are just sitting in my garage collecting dust. From what I have found, it says they are "SPARK PLUG SHIELD, LH front or RH rear, fits all small block engine only". If you are interested, make me an offer... I have no use for them.

http://67-72chevytrucks.com/vboard/s...d.php?t=415898

BTW, I have no idea if they are even correct for our trucks. They might be for a car... I just haven't been able to find out much about them.

I think they would work on anything with ram horn manifolds, but there are only enough for one side. I found these at LMC, but the whole set up is about $45 before shipping, so I was trying to find something a little more within budget.

http://www.lmctruck.com/icatalog/cb/full.aspx?Page=156

Thanks for the offer, though.