|
11-07-2010, 07:18 PM
|
#1 |
|
Registered User
Join Date: Jul 2010
Location: Peculiar, Missouri
Posts: 125
|
Cooling line question
I'm converting to an auto trans and I need to know how the trans lines run. Trans is a 350TH with 350V8. I was looking at them and assuming they both went to the inside of the engine mount? Are there any clips?
|
|
|
|
11-07-2010, 07:26 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Cooling line question
The lines route around the starter and beside the oil pan before going up to the radiator. There is one clip attached by a stud (which is used for one the oil pan bolts) that hold both lines.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
11-07-2010, 07:32 PM
|
#3 |
|
Sierra Grande Club
Join Date: Jan 2007
Location: New Mexico USA
Posts: 2,433
|
Re: Cooling line question
Yes, there's one big clip on the oil pan. The two small ones are for the plug wires.
s/t
__________________
1971 GMC Sierra Grande, 1/2 ton short wide, original 4 bolt 010 020 block & heads. (matching #'s). 383 stroker, SMI q jet 750 cfm, Lunati Voodoo 60102 cam, Scorpion roller rockers, Spin Tech pro street mufflers with X pipe. 
|
|
|
|
|
11-07-2010, 10:02 PM
|
#4 |
|
Registered User
Join Date: Jul 2010
Location: Peculiar, Missouri
Posts: 125
|
Re: Cooling line question
Great, exactly what I needed to know. Thanks!
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
