![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2011
Location: San Marcos, TX
Posts: 21
|
1970 GMC C2500 Question.
Hello,
I am new to the forum. I have a 1970 GMC C2500. I am swapping to disk brakes on the front. I purchased the upper and lower control arms, the rotors and spindles that came off a 1986 c20 Chevy from a local Austin, TX member on this forum. Here is my question, Will the linkages from the 1970 connect to the 1986? I have already bought new brake lines, calipers and pads to fit the 1986 front end. Are there any known problems that I should be aware of in this swap? I can not confirm that they are 1986, they may be 1985, etc. Will this make a difference? Any help, thoughts, or suggestions would be greatly appreciated. Dave |
![]() |
![]() |
![]() |
#2 |
Special Order
![]() ![]() Join Date: Nov 2004
Location: Mt Airy, MD
Posts: 85,859
|
Re: 1970 GMC C2500 Question.
Hello and welcome to the board. 85/86 won't matter...same thing. I believe you will need the 85/86 tie rod ends,IIRC.
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jan 2011
Location: San Marcos, TX
Posts: 21
|
Re: 1970 GMC C2500 Question.
I was afraid of that. I guess I need to find 1980's 3/4 ton tie rods now. Thank you for the info.
Dave |
![]() |
![]() |
![]() |
Bookmarks |
|
|