U:joint specs and size #'s - The 1947 - Present Chevrolet & GMC Truck Message Board Network

junkmen · 01-23-2011, 03:31 AM

Hey guy i could use some info on u:joint type's and sizes
OK here's what i have 82 GMC 1500 6.2L & 700R4 3 piece shaft and they are plastic injected joints in to 10 bolt diff I'm not sure what size joints these are next this is for a SWB conversion so my fiend gave me a one piece shaft that uses outer clips i think they are 1310 joints now the problem is it won't fit in the 10 bolt yoke so I'm thinking i need a 1310-1330 or 1310-1350 conversion joint any help is good thanks JM

Restrorob · 01-23-2011, 09:21 AM

JM,

I take both old joints to my local NAPA store, They measure them and pull me the right size. A good parts guy has no problem with doing this....

orbot · 01-23-2011, 09:59 PM

http://neapco.com/n_products-catalogs.php

click on the joint cataloge and then to chevy section, theres some more info for convertion joints almost at the end.

01-23-2011, 03:31 AM	#1
junkmen Registered User Join Date: Sep 2010 Location: tehachapi ca. Posts: 62	U:joint specs and size #'s Hey guy i could use some info on u:joint type's and sizes OK here's what i have 82 GMC 1500 6.2L & 700R4 3 piece shaft and they are plastic injected joints in to 10 bolt diff I'm not sure what size joints these are next this is for a SWB conversion so my fiend gave me a one piece shaft that uses outer clips i think they are 1310 joints now the problem is it won't fit in the 10 bolt yoke so I'm thinking i need a 1310-1330 or 1310-1350 conversion joint any help is good thanks JM

01-23-2011, 09:21 AM	#2
Restrorob The One And Only !!! Join Date: Jan 2007 Location: Hole in the woods Florida Posts: 4,567	Re: U:joint specs and size #'s JM, I take both old joints to my local NAPA store, They measure them and pull me the right size. A good parts guy has no problem with doing this.... __________________ 93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz ! The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. *"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!*

01-23-2011, 09:59 PM	#3
orbot Registered User Join Date: Jan 2008 Location: Chula Vista, Ca Posts: 518	Re: U:joint specs and size #'s http://neapco.com/n_products-catalogs.php click on the joint cataloge and then to chevy section, theres some more info for convertion joints almost at the end.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.