Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-09-2003, 02:51 AM | #1 |
Registered User
Join Date: Jul 2001
Location: reno, nv
Posts: 646
|
spark plug wire, hei module ?'s
how can you test a plug wire to see if it is good or not? is there a way to test the module in the hei without putting it in the motor? thanks
__________________
70 LWB, 350/350 A/C, P/S, 3 Tone Paint (white cap, primer gray with black guide coat) |
07-09-2003, 06:39 AM | #2 |
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Testing spark plug wires is easily done with an ohm meter. resistance will vary, but comparing readings to other wires in the set works. Any reading approaching infinity indicates a bad wire.
This test does not work for cracks or defects in the insulation if for example, a plug wire spark jumps to ground. An ohm meter can also be used on testing the module. I usually compare to known good module values. This is not a conclusive test but works in most cases. The other method that I use is to spin up a test distributor in my distributor machine. That is the best way that I know of testing a module. Jim |
Bookmarks |
|
|