|
07-27-2003, 11:51 PM
|
#1 |
|
Registered Abuser
Join Date: Nov 2002
Location: Ft.Worth Texas
Posts: 1,001
|
WTB axle
My brother-in-law needs the axle for the drivers side of a four wheel drive. 74' five lug (I think)
|
|
|
|
07-28-2003, 12:31 AM
|
#2 |
|
Gentleman Jim Driver
Join Date: Nov 2002
Location: Poulsbo, WA
Posts: 1,554
|
Front or rear? It should be six bolt on a 4wd.
__________________
Joe '75 GMC Gentleman Jim '84 Chev C10 Short Wide - Super duper plain (manual steering, manual brakes, no dome light, no cig lighter) '85 Chev C10 Short Wide - Super plain Vortec 4.8 4L60E trans also: '81 K30, '83 C30 Crew Dually, '84 M1028 CUCV, '85 M1009 CUCV, another '85 C10 SWB, '87 C10, '87 R30, 2 '89 R3500 Flatbeds |
|
|
|
|
07-28-2003, 12:06 PM
|
#3 |
|
Registered Abuser
Join Date: Nov 2002
Location: Ft.Worth Texas
Posts: 1,001
|
Oops front
|
|
|
|
|
07-29-2003, 10:08 PM
|
#4 |
|
Oh,you can't buy that new
 
Join Date: Apr 2000
Location: Pennsville,N.J. 08070, USA
Posts: 2,042
|
a 74 should also have the dana 44 and NOT the corporate 10 bolt used from 78? up. DAVE
__________________
"been there, done that, ruined the T-shirt". 2007 LBZ GMC Sierra, ECSB 2006 LM7 RCSB Silverado 98 Vortec project. 94,3500,6.5L 4L80 81 SWB GMC POS finally gone  73 Pinto, stock, w/CragarSS's-eww  84,C10 SWB-Yella,stock 86 K10 SWB-Red, hopped up 305,4/S LOTS of Cummins trucks. |
|
|
|
|
07-29-2003, 10:13 PM
|
#5 |
|
Gentleman Jim Driver
Join Date: Nov 2002
Location: Poulsbo, WA
Posts: 1,554
|
This is true, but I believe the axles themselves are actually interchangable.
__________________
Joe '75 GMC Gentleman Jim '84 Chev C10 Short Wide - Super duper plain (manual steering, manual brakes, no dome light, no cig lighter) '85 Chev C10 Short Wide - Super plain Vortec 4.8 4L60E trans also: '81 K30, '83 C30 Crew Dually, '84 M1028 CUCV, '85 M1009 CUCV, another '85 C10 SWB, '87 C10, '87 R30, 2 '89 R3500 Flatbeds |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
