|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-16-2011, 11:38 AM
|
#1 |
|
Registered User
 
Join Date: Nov 2011
Location: Lawrenceville Ga
Posts: 6
|
In need of a factory roll bar 72 blazer
After looking for a while for a nice gen 1 I have finally bought one. I don't know much about these yet. When I got it the roll bar, seat belts, and the arm rests on the rear seat have been removed. If anyone has some of these they are willing to sell let me know. I am about 30 minutes north of Atlanta Ga.
|
|
|
|
11-16-2011, 12:04 PM
|
#2 |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,707
|
Re: In need of a factory roll bar 72 blazer
I would drop down into the classified section(also blazer/jimmy only section) as there are over a thousand pages of stuff for sale
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
