![]() |
![]() |
#1 |
Registered User
Join Date: Mar 2003
Location: Sierra Vista, Arizona
Posts: 12
|
![]()
Question?
I am replacing my old alt. with an internally regulated one, I know that the stator side needs power when the key is on (I took the ignition hot from the old voltage reg.), but what do I run on the field side. The guy at the parts store said to just run a jumper from the alt. batt. wire, but that don't sound right to me. Thanks |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Feb 2001
Location: Salem , Oregon 97301
Posts: 1,796
|
|
![]() |
![]() |
![]() |
#3 |
Glowing since 1978
Join Date: Mar 2001
Location: Lusby,MD,USA
Posts: 532
|
Just did this today. Went from a one wire alternator to the normal internal regulated alternator. I chose to connect the Red to the Blue wire with a butt connector and the Brown to White wire with a butt connector. Bought the connector at Advanced Auto. They call it an extender. It has a Red and a Black wire on it. I call it my new alternator plug. I removed the wires from the extender keeping track of where the Red wire was on the extender. I then placed a Packard 56 type connector on the Blue wire and put it in the plug in the spot the Red wire use to be. I did the same with the white wire and it almost looks stock. I bought an alternator for a 75 C20. I required some shims on the bottom bracket. I used washers to take up the gap. The two halves of the alternator were 180 degrees out. I removed the pulley/fan from the shaft and removed the four bolts holding the halves together. I used a screw driver to pry the front half up high enough to rotate it to the new orientation and bolted it back together. Care should be exercised when doing this to prevent the back half from separating unless you enjoy reinstalling those brushes.
__________________
66 Chevy C30 Stakebody Dump, PS,PB, 327cu in 71 Corvette Coupe 454 4 speed 69 Chevy C20 Custom Camper Last edited by ddsmith; 09-06-2003 at 08:51 PM. |
![]() |
![]() |
![]() |
Bookmarks |
|
|