Billet dash question

[BIG D 85 gmc]

I just bought a billet dash and was wondering if anyone who has one had to do any modifications as far as cutting I bought this one. http://item.mobileweb.ebay.com/viewi...id=42540679120
Posted via Mobile Device

[longbed67]

I am in the process of CNC'ing a billet dash right now, and if it is flat on the back and not recessed you will have to cut the two tabs that stick forward about 1/4" on the top so that they are flush, be careful to only take the part that stick out and nothing more, but be sure to line it up and measure 10 times and cut once! Good Luck!

[BIG D 85 gmc]

Originally Posted by longbed67

I am in the process of CNC'ing a billet dash right now, and if it is flat on the back and not recessed you will have to cut the two tabs that stick forward about 1/4" on the top so that they are flush, be careful to only take the part that stick out and nothing more, but be sure to line it up and measure 10 times and cut once! Good Luck!

Thx for the help I figured I had to do that just wanted to make sure
Posted via Mobile Device