|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-22-2003, 02:02 PM
|
#1 |
|
Registered User
Join Date: Jun 2001
Location: Eastern Kansas
Posts: 488
|
Replacing 1/4 window fuzzies?
I have a "repop" brand of fuzzies replacement kit. Everything looks straight forward so far, but I have a question about the straight fuzzy in the channel that is at the back edge of the 1/4 vent window (the channel at the front edge of the window that slides up and down). The original piece has a cloth edge that is pinched under a piece of chrome bead. The replacement appears to be designed to not require that its edges be pinched underneath the chrome bead. Is that how it is supposed to work? Is there other kits that install the original way? Thanks in advance.
Randy
__________________
'72 Cheyenne. AC, PS, PB, Rear slider window, tilt. Light yellow (grapefruit yellow according to new sales literature from '72) '56 Chevy short step V-8 (My dad bought it new!!) '70 Olds 442 convertible '70 Olds Rallye 350 |
|
|
|
09-22-2003, 05:19 PM
|
#2 |
|
Senior Member
Join Date: Dec 2000
Location: Indiana
Posts: 3,074
|
Just take a razor knife, cut down both side of the division bar felt and pull it out. You can use a little glue in the channel, thenjust push the new division bar felts back into the division bars.
__________________
71 Chevy CST Long Fleet 350/350/3.07 leaf rear. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
