The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 09-14-2012, 12:28 PM   #1
stevel
Registered User
 
stevel's Avatar
 
Join Date: Oct 2011
Location: enid ok.
Posts: 43
Changing Gear Ratio

I have a 69 step-side with 3 speed on the column and a 6cyl. Want to change my gear ratio so as not to be at such hi RPMs at hi-way speed.
Can anyone tell me the most cost effective and simplest way to accomplish this? At such speeds my fuel millage is horrible.
stevel is offline   Reply With Quote
Old 09-14-2012, 12:55 PM   #2
my67c20
Registered User
 
Join Date: Jun 2002
Location: Tucson AZ by way of WI & CA
Posts: 509
Re: Changing Gear Ratio

Need more info. What rear gears do you currently have? What RPM's are you at at 55 or 65mph? What size tires? How much are you willing to spend? What type of rear axle do you have? Can you post pictures so we might be able to identify the axle? Did you already search for similiar situations (had to throw that in). Cheapest would be to change the size of tires, then the third member or rear gears (if you have an eaton), then axle for a decrease in RPM's. What kind of fuel mileage are you currently getting? When was the last time you did a compete tune-up? Points or HEI? Chrome or dull engine parts? How far do you drive? Loaded or unloaded? Manual or automatic choke? Answer some of these and we should be able to at least make you feel the desperation that most of us feel by chasing the elusive mpgs. And on a side note i only get 10mpg
my67c20 is offline   Reply With Quote
Old 09-14-2012, 01:01 PM   #3
Billett
Registered User
 
Billett's Avatar
 
Join Date: Jun 2012
Location: Pittsgrove, NJ
Posts: 1,502
Re: Changing Gear Ratio

About 10 here too... I usually just drive slower on the highway, closer to 55-60. People pass me, and some get mad because I'm holding up a bit of traffic but it doesn't bother me any. Some things I did to get some more mileage: change the oil, check the tire pressures, and grease everything!
__________________
Will
1968 C10 - Project Texa Go 6.0/4L80e
2003 Mitsubishi Lancer Evolution
2002 Ford Excursion 7.3L
2024 Toyota Sienna
Billett is offline   Reply With Quote
Old 09-14-2012, 01:07 PM   #4
cdowns
Senior Member
 
cdowns's Avatar
 
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
Re: Changing Gear Ratio

lots of guys have gone to "hiway gears" to get increases in gas milage only to find out that with the around town driving the the effort it takes to get to "cruisin" speed they actually killed thier gas milage and got worse in the long run/// tires suspension routine maintenence can do alot to improve what you have
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane

MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF

DONT BELIEVE EVERYTHING YOU THINK

TAKE MY ADVISE;I DON'T USE IT ANYWAY
cdowns is offline   Reply With Quote
Old 09-14-2012, 01:13 PM   #5
Billett
Registered User
 
Billett's Avatar
 
Join Date: Jun 2012
Location: Pittsgrove, NJ
Posts: 1,502
Re: Changing Gear Ratio

Also, if you're not looking at mpg's, only to lower your RPM's at cruising, you'll have to change transmissions for that... you could do a different rear end, but I doubt it would help much.
__________________
Will
1968 C10 - Project Texa Go 6.0/4L80e
2003 Mitsubishi Lancer Evolution
2002 Ford Excursion 7.3L
2024 Toyota Sienna
Billett is offline   Reply With Quote
Old 09-14-2012, 01:15 PM   #6
davepl
Registered User
 
davepl's Avatar
 
Join Date: Aug 2006
Location: Redmond, WA
Posts: 6,332
Re: Changing Gear Ratio

Sticking a later model overdrive transmission like a TH200 or TH700 in it would help. The overdrive is about 0.7 so cuts your overall gear ratio substantially. Done correctly you can also get a lockup converter for the highway which will also help.

All that work might take you from 12 to 14 mpg though. No matter how efficient your powertrain, these are still big, heavy, brick-shaped trucks.

In my Range Rover, which is only slightly more aerodynamic, I see a huge difference in mileage between 55mph and 75mph (like 4-5 mpg). Unless you're doing a ton of highway driving frequently with it I'd leave 10 minutes early, keep the speed down a little, which will keep the RPMs down and improve the mileage.
__________________
1970 GMC Sierra Grande Custom Camper - Built, not Bought
1969 Pontiac 2+2 427/390 4-speed Coupe
1969 Pontiac 2+2 427/390 4-speed Convertible
davepl is offline   Reply With Quote
Old 09-14-2012, 03:14 PM   #7
Billett
Registered User
 
Billett's Avatar
 
Join Date: Jun 2012
Location: Pittsgrove, NJ
Posts: 1,502
Re: Changing Gear Ratio

And its a more relaxing drive
Posted via Mobile Device
__________________
Will
1968 C10 - Project Texa Go 6.0/4L80e
2003 Mitsubishi Lancer Evolution
2002 Ford Excursion 7.3L
2024 Toyota Sienna
Billett is offline   Reply With Quote
Old 09-14-2012, 03:18 PM   #8
GASoline71
"I ain't nobody, dork."
 
GASoline71's Avatar
 
Join Date: Sep 2007
Location: Whidbey Island, Washington
Posts: 8,957
Re: Changing Gear Ratio

Quote:
Originally Posted by davepl View Post
All that work might take you from 12 to 14 mpg though. No matter how efficient your powertrain, these are still big, heavy, brick-shaped trucks.
Couldn't agree more...

Gary
__________________
'cuz chicks dig scars...

My 1972 GMC 1500 Super Custom (Creeping Death) "long term" build thread.

The Rebuild of Creeping Death after the wreck

Quote:
Originally Posted by LONGHAIR View Post
I would never rebuild a 305.
Quote:
Originally Posted by prostreetC-10 View Post
I love using vacuum gauges as part of the carb tuning process. I hook the gauge to the inside of my garbage can and leave it there.
Quote:
Originally Posted by Marv D View Post
Remember Murphys 2nd law of mechanical relationships... "OPPOSING COMPONENTS ATTEMPTING TO OCCUPY THE SAME SPACE, AT THE SAME TIME, GENERALLY END UP OCCUPYING ADJOINING SPACE AT THE BOTTOM OF THE OIL PAN"
Quote:
Originally Posted by cableguy0 View Post
Its cheaper to listen to advice given when you ask for help than it is to ignore everyone and wait for carnage.
GASoline71 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:04 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com