LMC Seat Belts barely poke through the bench seat

[ubtripn]

I think I have the thicker foam seat but is this normal or are there extensions. It's a bit of a pain. Thanks.

Also, if somebody has a pic of the way the receiving belt with the female end bolts to the floor it would help. I just did mine so it would have the most reach, facing up.

[JVictor75]

Originally Posted by ubtripn

I think I have the thicker foam seat but is this normal or are there extensions. It's a bit of a pain. Thanks.

Also, if somebody has a pic of the way the receiving belt with the female end bolts to the floor it would help. I just did mine so it would have the most reach, facing up.

I'm sorry to say this, but of all the items I've ordered over the years from LMC not a single one fit as intended straight out of the box.

No single fastener has ever been the same size/fitment as the factory fastener, no sheetmetal piece has ever fit even close to correctly.

I take that back. The stock height coil springs for the 71 LWB C10 fit fine, as did the replacement rubber sway bar bushings, and the I/O tie rods.

Everything else has been a crap shoot.

[ubtripn]

Yeah, that has been the case for me as well. Bolts were not the right thread, had to go buy them as well.

[69GWC]

Guess I have been lucky with LMC have not had any problems with there products everything has fit fine.
Posted via Mobile Device